Western Star — Western Star (EN)

In An Emergency NOTICE Make sure both electrical systems are the same voltage. Electronic devices on both vehicles can be damaged when connected to a vehicle with a different operating voltage. 3 POS JUMP START STUD 2 IMPORTANT: Do not attempt to jump start a damaged or frozen battery. NEG JUMP START STUD 1. Set the parking brake and turn off all lights and other electrical devices. Ensure that the vehicles are not touching and both ignition switches are turned to the OFF position. 2. Access the batteries by removing the battery box cover, if equipped. 1 01/07/2011 f545726 NOTICE 1. Frame Rail 2. Negative Jump Start Post 3.

Positive Jump Start Post Always connect the batteries and jumper cables correctly (positive-to-positive and negative-to- negative). Connecting a charging device back- wards (positive-to-negative) can severely damage the vehicle electrical content and cause non- warrantable failures. Fig. 21.4, Possible Jump Start Post Location (passenger-side engine compartment) 6. Connect the other end of the negative jumper cable to the negative ground stud on the vehicle requiring the jump start. IMPORTANT: On vehicles equipped with op- tional jump start posts, connect to these posts instead of the battery terminals. Jump start posts may be installed in various locations on the vehicle. See Fig. 21.4 . 7.

Start the engine of the vehicle providing the jump start and let the engine run a few minutes to charge the batteries of the other vehicle. 8. Attempt to start the engine of the vehicle receiv- ing the jump. Do not operate the starter longer than 30 seconds, and wait at least two minutes between starting attempts to allow the starter to cool. 3. Connect the positive (+) jumper cable to the positive terminal or jump start post on the dis- charged battery. See Fig. 21.5 . 4. Connect the other end of the positive jumper cable to the positive terminal or jump start post on the booster battery providing the charge. 9. When the engine starts, let it idle a few minutes.

WARNING WARNING Do the next step exactly as instructed and do not allow the clamps of one cable to touch the clamps of the other cable. Otherwise, a spark could occur near a battery, possibly resulting in severe personal injury from explosion or acid burns. Do the next step exactly as instructed and do not allow the clamps of one cable to touch the clamps of the other cable. Otherwise, a spark could occur near a battery, possibly resulting in severe personal injury from explosion or acid burns. 10. Disconnect the negative jumper cable from the jump started vehicle. 5. Connect the negative (-) jumper cable to the negative terminal or jump start post on the booster battery. 11.

Disconnect the negative jumper cable from the vehicle that provided the jump start. 21.3