Western Star — Western Star (EN)

In An Emergency Rear Towing Hookup NOTICE Using a rear towing hookup on a vehicle equipped with a roof fairing could cause damage to the cab structure. If reverse towing at speeds above 45 mph (70 kph) is necessary, hold down the cab with ten- sion straps looped over the cab shocks and under the frame rails. Failure to do so could allow the wind load to lift the cab unexpectedly, resulting in damage to the air springs and other components. 1. If the vehicle is equipped with cab air suspen- sion, and reverse towing at speeds above 45 mph (70 kph) is necessary, hold down the cab as follows: 1.1 Drain the air from the cab air springs.

1.2 Loop a 2-inch (5-cm) ratchet-style tension strap (rated 2000 lb [900 kg] minimum work load) over the top of the cab shock and under the frame rail. See Fig. 21.6 . Tighten the strap for a snug fit. If the cab is equipped with two or more shocks, re- strain the aftmost shock on each side of the vehicle. 06/24/2014 f602530 NOTE: Typical cab air suspension shown. Fig. 21.6, Tension Strap Installed to Hold Down the Cab 6. Lift the vehicle and secure the safety chains. If extra clearance is needed, remove the bumper extension if equipped. 2. Place the front tires straight forward and secure the steering wheel in this position. 7. Connect the clearance lights, taillights, and sig- nal lights.

Also connect any special towing lights required by local regulations. 3. Disconnect the battery ground cables. NOTICE Fire in the Cab Failure to protect the frame rails from the chains could cause damage, leading to eventual frame failure. According to data from the National Highway Traffic Safety Administration, the incidence of fire in heavy- and medium-duty trucks is rare. Federal Motor Ve- hicle Safety Standard #302 limits the flammability of specified materials used inside the cab, but despite this, most materials will burn. The cab of this vehicle contains urethane foam, which is flammable. 4.

On dual drive axles, using protection to keep the chains from damaging the vehicle frame, chain the forward-rear drive axle to the frame. 5. Attach the towing device. NOTE: Due to the many variables that exist in towing, positioning the lifting and towing device is the sole responsibility of the towing-vehicle operator. WARNING Urethane foam is flammable! Do not allow any flames, sparks, or other heat sources such as cigarettes or light bulbs to contact urethane foam. Urethane foam in contact with such heat sources could cause a serious, rapid fire, which 21.6