Western Star — Western Star (EN)

In An Emergency the gross axle weight ratings (GAWR) of the tow- ing vehicle. Otherwise brake capacity will be in- adequate, which could result in personal injury or death. NOTICE Do not pass a sling (for example, a rope or chain) from one tow hook to another to fasten for tow- ing. Known as reeving, this practice is not per- missible in most industrial applications of towing and hoisting. Reeving can overload the hooks and result in damage to the vehicle. Front Towing Hookup 1. Disconnect the batteries at the negative termi- nals. NOTICE 6. Attach the towing device.

Due to the many vari- ables that exist in towing, positioning the lifting and towing device is the sole responsibility of the towing-vehicle operator. Failure to remove the axle shafts or the driveline when towing the vehicle with the rear wheels on the ground could result in damage to the trans- mission and other parts. 7. On vehicles equipped with an air fairing, mea- sure the distance from the ground to the bumper, or from the ground to a frame bracket. 2. Remove the driveline from any drive axle that will have its wheels touching the ground while the vehicle is towed, 8. Lift the vehicle, and secure the safety chains. If extra towing clearance is needed, remove the front wheels.

or remove the drive axle shafts on both sides of the vehicle from any drive axle that will have its wheels touching the ground while the vehicle is towed. WARNING Failure to lower the vehicle could result in the air fairing striking an overhead obstruction, such as a bridge or overpass, and causing vehicle dam- age or personal injury. 3. If the axle shafts were removed, cover the ends of the hubs with metal plates or plywood cut to fit the axle opening, and drilled to fit the axle shaft studs. This prevents lubricant from leaking out and will keep contaminants from getting into and damaging the wheel bearings and axle lubricant. 9.

On vehicles equipped with an air fairing, repeat the measurement taken in step 8. The difference between the two measurements must not exceed 14 inches (36 cm). If necessary, lower the ve- hicle. If the driveline(s) were removed, ensure the U-joint caps are secure so they will not come off. 10. Connect the clearance lights, taillights, and sig- nal lights. Connect any special towing lights re- quired by local regulations. NOTICE Failure to protect the frame rails from the chains could cause damage, leading to eventual frame failure.

WARNING Failure to chock the tires or connect the tow truck’s air brake system before releasing the spring parking brakes could allow the disabled vehicle to suddenly roll. This could cause prop- erty damage or personal injury. 4. If a vehicle with tandem rear axles is to be lifted and towed, chain the forward rear-axle assembly to the vehicle frame. This will prevent the forward rear-axle assembly from dropping and keep its wheels off the ground while being towed. 11. Chock the tires on the disabled vehicle and con- nect the towing vehicle’s air brake system to the vehicle being towed. Then, release the spring parking brakes and remove the chocks.

Use protection to keep the chains from damaging the frame. 5. Remove the bumper extension and chrome bum- per, if so equipped. Remove the bumper fairing, if so equipped. 21.5