Pre- and Post-Trip Inspections and Maintenance Safety Precautions spring hangers DANGER shocks suspension arms When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. Daily Pretrip Inspections and Maintenance suspension brackets axle seats bushings 2. Inspect slack adjusters for signs of damage. See Fig. 23.1 , Fig. 23.2 , or Fig. 23.3 .
4 5 Complete the following inspection and maintenance procedures to ensure that vehicle components are in good working condition before each trip. A driver that is familiar with the vehicle and drives it regularly can perform the daily inspections, then add the weekly and monthly post-trip inspections as scheduled. 6 3 7 8 If the driver does not operate the vehicle on a con- sistent basis, all daily, weekly, and monthly inspec- tion and maintenance procedures should be per- formed before the trip. 2 9 1 10 IMPORTANT: The pre- and post-trip checklists, inspections, and maintenance procedures de- tailed in this chapter are not all-inclusive .
Refer to other component and body manufactur- ers’ instructions for specific inspection and maintenance instructions, as well as local, state, and federal guidelines. f421398 06/17/2003 1. 7/16-inch Adjusting Nut 2. Grease Fitting 3. Boot 4. Link 5. Brake Chamber Piston Rod 6. Clevis 7. Ѕ-inch Clevis Pin 8. 1/4-inch Clevis Pin 9. Grease Relief Opening 10. Slack Adjuster Spline NOTE: If any system or component does not pass this inspection, it must be corrected before operating the vehicle. Whenever equipment re- quires adjustment, replacement, and/or repair, see the Western Star Workshop Manual for pro- cedures and specifications. Fig.
23.1, Gunite Automatic Slack Adjuster Inspect slack adjuster boots, if equipped, for cuts or tears. Suspension and Slack Adjuster Inspection Inspect anchor straps, if equipped, for damage. Walk around the vehicle and visually inspect suspen- sion and slack adjuster components. Look for worn clevis pins on brake cham- ber pushrods. 1. Inspect the following suspension components for signs of structural damage, cracks, or wear. Look for missing or damaged cotter pins on the clevis pins. springs 23.1