Western Star — Western Star (EN)

Pre- and Post-Trip Inspections and Maintenance 1 2 3 4 3 5 7 6 4 8 9 8 7 6 5 2 10/11/2005 f421397 A A. Rotate the control arm toward the brake chamber until you can feel it contacting the internal stop. 1. Clevis 2. Slack Adjuster 3. Clevis Pin 4. Manual Adjusting Nut 5. Control Arm 6. Control-Arm Washers and Nut 7. Anchor Strap Slot 8. Anchor Strap 9. Brake Chamber 9 10 01/31/2011 f422530 1 1. Grease Fitting (if equipped) 2. Slack Adjuster Housing 3. Brake Chamber Pushrod 4. Clevis 5. Clevis Pin (large) 6. Clevis Pin (small) 7. Actuator Rod 8. Boot 9. Manual Adjusting Nut 10. Camshaft Splines Fig.

23.2, Haldex Automatic Slack Adjuster Ensure chamber piston rods are in line with the slack adjusters. Wheel and Tire Inspection Walk around the vehicle and visually inspect each wheel and tire assembly. Fig. 23.3, Meritor Automatic Slack Adjuster IMPORTANT: Wheel covers decrease drag force as a vehicle moves, thereby improving fuel effi- ciency. If replacement of a wheel cover is nec- essary, the replacement cover must meet or ex- ceed the drag reduction performance of the originally installed cover in order to maintain compliance with greenhouse gas and full effi- ciency regulations (GHG14). prior to inspecting the tires and wheel compo- nents. NOTE:

During wheel cover installation, ensure the V-notch in the liner inner retaining ring is centered on the valve stem. The inner and outer retaining rings should be uniformly aligned to each other and to the wheel rim. The outer re- taining ring of the liner is equipped with two canvas flaps. When installing the face cover, make sure the cover retaining ring is inserted between the two canvas flaps on the liner outer retaining ring so that the Velcro strips line up 1. If the vehicle was originally equipped with wheel covers, ensure all wheel covers are present. In- spect wheel covers for damage or wear. Remove wheel covers from rear drive wheels, if equipped, 23.2