Western Star — Western Star (EN)

Pre- and Post-Trip Inspections and Maintenance between the face cover and the liner. Make cer- tain the detachable view cover is centered on the face cover, and the Velcro strips are pressed firmly in place. Keep compressed air reservoirs and lines dry during tire inflation. Use well-maintained inline moisture traps and service them regularly. NOTICE 2. Inspect each tire for the following: A weekly pressure loss of 4 psi (28 kPa) or more in a tire may indicate damage. The tire should be inspected and, if necessary, repaired or replaced by a qualified tire service facility.

valve stem caps on every tire, screwed on finger-tight bulges, cracks, cuts, and penetrations oil contamination (petroleum derivatives will soften the rubber and destroy the tire) IMPORTANT: The load and cold inflation pres- sure must not exceed the rim or wheel manu- facturer’s recommendations, even though the tire may be approved for a higher load inflation. Consult the rim or wheel manufacturer for the correct tire inflation pressure for the vehicle load. tread depth—if tread is less than 4/32 inch (3 mm) on any front tire, or less than 2/32 inch (1.5 mm) on any rear tire, replace the tire debris lodged between duel tire sets 4. Examine each rim and wheel component.

Check the wheel nuts or rim nuts for indications of looseness. IMPORTANT: Low-rolling resistance (LRR) tires minimize wasted energy as a tire rolls, thereby decreasing rolling effort and improving fuel effi- ciency. If tire replacement is necessary, replace- ment tires must meet or exceed the rolling resis- tance of the originally installed tires in order to maintain compliance with greenhouse gas and full efficiency regulations (GHG14). 4.1 Remove all dirt and debris from the as- sembly. Rust streaks or metal build-up around stud holes, or out-of-round or worn stud holes, may be caused by loose wheel nuts.

Contact your tire manufacturer/supplier to deter- mine the rolling resistance of the originally in- stalled tires. Visit www.epa.gov/smartway for additional information and resources. WARNING Have any worn or damaged wheel components replaced by a qualified person using the wheel manufacturer’s instructions and the wheel indus- try’s standard safety precautions and equipment. Otherwise a vehicle or workshop accident could occur, possibly resulting in serious personal in- jury or death. WARNING Do not operate the vehicle with underinflated or overinflated tires.

Incorrect inflation can stress the tires and make the tires and rims more sus- ceptible to damage, possibly leading to rim or tire failure and loss of vehicle control, resulting in serious personal injury or death. 4.2 Inspect for broken, cracked, badly worn, bent, rusty, or sprung rings and rims. See Fig. 23.4 . 3. Check tire inflation. For inflation pressures and maximum loads, see the tire manufacturer’s guidelines. Inflate the tires to the applicable pressures if needed. NOTICE Use the recommended torque values and follow the proper tightening sequence. Insufficient wheel nut torque can cause wheel shimmy, re- sulting in wheel damage, stud breakage, and ex- treme tire tread wear.

Excessive wheel nut torque If a tire has been run flat or under-inflated, check the wheel and tire for damage before adding air. 23.3