Western Star — Western Star (EN)

Pre- and Post-Trip Inspections and Maintenance 02/09/95 f400001 Fig. 23.4, Worn Stud Holes can break studs, damage threads, and crack discs in the stud hole area. 1 4.3 Make sure all wheel nuts are tightened. If tightening is necessary, use the tightening pattern in Fig. 23.5 or Fig. 23.6 . 10 8 When tightening a 12-stud wheel rim, use the tightening sequence in Fig. 23.7 for each of the three stages of tightening as follows: 3 6 4 5 Stage 1—Tighten each nut 50 lbf·ft (68 N·m) 7 2 9 Stage 2—Tighten each nut 100 lbf·ft (136 N·m) f400081a 08/23/93 Stage 3—Tighten each nut 150 lbf·ft (203 N·m) Fig. 23.5, Tightening Sequence, 10-Stud Disc Wheels 5.

Inspect the outboard side of all wheel hubs and the hub oil seal area on the inboard side of each wheel for signs of oil leakage. If any oil is found on wheel and tire or brake components, remove the vehicle from service until the leak has been fixed. 1 2 7 4 If needed, fill the hubs to the level indicated on the hub cap. See Group 35 of the Western Star Maintenance Manual for recommended lubri- cants. 5 6 6. Check that mud flaps are undamaged and hang 10 inches (25.4 cm) or less from the ground. 8 03/08/2012 3 f400052a Fig. 23.6, Tightening Sequence, 8-Stud Disc Wheels 23.4