Pre- and Post-Trip Inspections and Maintenance IMPORTANT: On engines that comply with EPA07 or newer regulations, use CJ-4 en- gine oil with less than 1% sulfated ash. Fail- ure to use CJ-4 oil may void the warranty on emission aftertreatment components. engine after refilling and check the sight glass again when the engine is at operat- ing temperature. 3.2 If the oil level is at or below the minimum fill (or "add") mark on the dipstick, add enough oil to maintain the level between the minimum and maximum fill marks. See the engine operation manual for recom- mended lubricants. 1 4. Check the power steering reservoir fluid level.
The power steering fluid level should be between the MIN COLD mark and the middle mark just above it. See Fig. 23.8 . If needed, fill the reser- voir with automatic transmission fluid that meets Dexron III or TES-389 specifications. 2 3 1 06/06/2001 f500354 1. Surge Tank 2. Filler Cap Fig. 23.9, Steel Surge Tank Translucent Surge Tank : If the coolant is low, fill the surge tank to the FULL line with a 50/50 mixture of water and antifreeze. See Fig. 23.10 . Start the engine after refill- ing and check the level again when the engine is at operating temperature. 05/21/2007 f462079 1. Filler Cap Fig. 23.8, Power Steering Fluid Reservoir (configuration may vary) 6.
Inspect visible engine wiring for damage or looseness. See Fig. 23.11 . Check for loose wir- ing, chafed insulation, and damaged or loose hold-down clamps. NOTICE 7. Inspect visible frame rails for missing bolts, shiny areas, or rust streaks. Low coolant could result in engine overheating, which could cause engine damage. IMPORTANT: The surge tank must be cool to check the coolant level. Cab Inspection 1. Push the reset button on the dash-mounted air intake restriction indicator, if equipped. 5. Check the engine coolant level in the radiator surge tank. 2. With the ignition switch in the OFF position, check the air-pressure warning system. Steel Surge Tank :
Ensure coolant is visible in the sight glass. See Fig. 23.9 . If coolant is not visible, add a 50/50 mixture of water and antifreeze to the surge tank until cool- ant is visible in the sight glass. Start the 2.1 If not previously drained, drain the air res- ervoirs using moderate brake applications until pressure in both reservoirs is less than 70 psi (483 kPa). 23.6