Pre- and Post-Trip Inspections and Maintenance 2 1 09/07/2011 f200745 1. Filler Cap 2. Sight Glass 3. Low Coolant Sensor 2 1 Fig. 23.10, Plastic Surge Tank 04/12/2010 f545646 2.2 Turn the ignition to the ON position. The ICU will complete a full gauge sweep and bulb check, and the warning buzzer will sound. Ensure the BRAKE AIR lamp re- mains illuminated and the warning buzzer continues to sound after the gauge sweep is complete. 1. Powertrain PDM (PTPDM) 2. Powernet Distribution Box (PNDB) 4.1 With the air system fully charged, make one full brake application and note the air pressure reading on the primary air gauge. Fig. 23.11, Visible Engine Wiring 3.
Check air governor cut-in and cut-out pressures. 3.1 Start the engine and ensure the BRAKE AIR lamp goes out and the buzzer si- lences when pressure reaches approxi- mately 70 psi (483 kPa) in both air reser- voirs. 4.2 Further reduce air pressure using moder- ate brake applications, then run the en- gine at governed rpm. 4.3 Note the time that the pressure reaches the previously noted reading on the pri- mary air gauge, then note the time that the air pressure reaches cut-out pressure. The air governor should cut out at ap- proximately 120 psi (827 kPa). For ve- hicles with an optional dryer reservoir module (DRM), the cut-out pressure is approximately 130 psi (896 kPa).
4.4 If it takes longer than 30 seconds to reach cut-out pressure after the primary air gauge passes the previously noted pres- sure (noted after one full brake applica- tion), eliminate any leaks or replace the air compressor before operating the vehicle. 3.2 With the engine idling, apply the brake pedal several times. The air governor should cut in when pressure in the primary air reservoir (top air gauge) reaches ap- proximately 100 psi (689 kPa). 5. Check air leakage in the system. 4. Check air pressure build-up time. 23.7