Pre- and Post-Trip Inspections and Maintenance 5.1 With the parking brake applied, the trans- mission out of gear, and the air system fully charged, release the service brakes and shut down the engine. 10.1 Turn on the headlights and leave them on. Ensure all equipped gauge bulbs illumi- nate in the dash message center. 10.2 Ensure all equipped driver control switches illuminate. 5.2 Wait one minute and note the air pressure drop in psi (kPa) per minute from the pri- mary air reservoir. 10.3 Ensure both turn signal indicator bulbs illuminate in the dash message center when the turn signal switch is activated.
If the pressure drop exceeds the limits shown in Table 23.1 , eliminate any leaks before operating the vehicle. 11. Check the operation of all exterior lights. See 6. Check the air pressure reserve. Fig. 23.12 . With the engine still off, make one full brake ap- plication and observe the pressure drop on the primary air gauge. If pressure drops more than 25 psi (172 kPa), eliminate any leaks before op- erating the vehicle. 1 Description Pressure Drop:
psi (kPa) Per Minute Released Applied Truck or Tractor Only 2 (14) 3 (21) Truck or Tractor w/Single Trailer 3 (21) 4 (28) Maximum Allowable Air Leakage 5 2 3 Table 23.1, Maximum Allowable Air Leakage 4 WARNING When cleaning windshields and windows, always stand on the ground or on a secure ladder or platform. Use a long-handled window cleaner. Do not use the cab steps, tires, fenders, fuel tanks, engine, or under-hood components to access the windshield or windows. Doing so could cause a fall and result in an injury. 06/06/2001 1. Clearance Lights 2. Turn Signal Light 3. Headlight 4. Driving/Fog Lights 5. Marker Lights f602091 Fig.
23.12, Exterior Lights 11.1 Activate the high-beam headlights and hazard warning lights. 7. Inspect the mirrors, window glass, and wind- shield for cracks or other damage. 11.2 Exit the cab and check that all exterior lights and reflectors are clean and intact. 8. Ensure that the horn, windshield wipers, and windshield washers are operating properly. These devices must be in good working order for safe vehicle operation. 11.3 Check that the brake lights, taillights, headlights, turn signals, marker lights, identification lights, and clearance lights are working properly. 9. Ensure the heater and defroster are operating properly. 12. Inspect the seat belts and tether belts. 10.
Check the operation of all interior lights. 23.8