Pre- and Post-Trip Inspections and Maintenance WARNING 13. Check the fuel level in the fuel tank(s). To keep condensation to a minimum, fuel tanks should be filled at the end of each day. Inspect and maintain seat belts. When any part of a seat belt system needs replacement, the entire seat belt must be replaced, both retractor and buckle side. Any time a vehicle is involved in an accident, and the seat belt system was in use, the entire vehicle seat belt system must be re- placed before operating the vehicle. Do not at- tempt to modify the seat belt system; doing so could change the effectiveness of the system.
Failure to replace worn or damaged seat belts, or making any modifications to the system, may re- sult in personal injury or death. 14. Adjust the rearview and down view mirrors as necessary. 15. Test the service brakes. 15.1 With the engine running and air system fully charged, set the parking brake. 15.2 Put the vehicle in the lowest gear and gently attempt to move it forward. The ve- hicle should not move. 12.1 Check the web for fraying, cuts, extreme dirt and dust, or for severe fading from exposure to sunlight, especially near the buckle latch plate and in the D-loop guide area.
If the vehicle moves, the parking brakes are not operating correctly and must be repaired before the vehicle is operated. 16. Test the backup alarm 16.1 Release the parking brake and put the transmission in reverse. 12.2 Check operation of the buckle, latch, Kom- fort Latch or Sliding Komfort Latch (if equipped), web retractor, and upper seat belt mount on the door pillar. Check all visible components for wear or damage. 16.2 Move the vehicle slightly backward to en- sure that the backup alarm is operating correctly. Weekly Post-Trip Inspections and Maintenance Engine Compartment Inspection 12.3 Check the seat belt and tether belt con- nection points and tighten any that are loose.
WARNING WARNING Never fill fuel tanks to more than 95 percent of their liquid capacity. This could make them more likely to rupture from impact, possibly causing fire and resulting in serious personal injury or death by burning. Washer fluids may be flammable and poisonous. Do not expose washer fluid to an open flame or any burning material, such as a cigarette. Always comply with the washer fluid manufacturer’s rec- ommended safety precautions. Do not mix gasoline or alcohol with diesel fuel. This mixture could cause an explosion, possibly resulting in serious personal injury or death. Do not fill the fuel tanks in the presence of sparks, open flames, or intense heat.
These could ignite the fuel, possibly causing severe burns. 1. Check the windshield washer reservoir fluid level. The reservoir is usually located near the right- hand frame rail. 2. After resetting the air intake restriction indicator during the daily pretrip inspection, check the indi- cator again with the engine off. IMPORTANT: On engines that comply with EPA07 or newer regulations, use ultralow-sulfur diesel (ULSD) with 15 ppm sulfur content or less. Failure to use ULSD fuel may void the warranty on emission components. 2.1 Check an indicator with graduations to see if air restriction exceeds the value shown in Table 23.2 .
Check a go/no-go indicator without gradu- ations to see if the colored bar shows through the clear window. 23.9