Western Star — Western Star (EN)

Pre- and Post-Trip Inspections and Maintenance Air Intake Maximum Restriction Values (inH 2 O) DAVCO Models : Remove the vent cap and open the drain. See Fig. 23.14 . Engine Make Pre-EPA07 Engines EPA07 and EPA10 Engines GHG14 Engines ConMet Models : Check the water level in the sight bowl, if so equipped. To drain the water, loosen the valve at the bottom and allow the water to run out. See Fig. 23.15 . Detroit 20 22 18 Cummins 25 25 25 Mercedes-Benz 22 22 Caterpillar 25 Table 23.2, Air Intake Maximum Restriction Values 5 6 2.2 If air restriction exceeds the maximum al- lowable value, operate the vehicle for one more day, making sure not to run the en- gine over rated rpm.

Refer to the engine operation manual for more information on rated rpm for your engine. 3 4 7 2 2.3 If air restriction exceeds the maximum value again, replace the air cleaner. For instructions, refer to Group 09 of the Western Star Workshop Manual . 1 8 3. If the vehicle is equipped with an Allison auto- matic transmission, check the automatic trans- mission fluid level. 9 10 4. Check for water in the fuel/water separator, if equipped. 11 IMPORTANT: When draining fluid from a fuel/water separator, drain the fluid into an appropriate container and dispose of it prop- erly. Many jurisdictions now issue fines for draining fuel/water separators onto the ground. 02/03/2010 f470552 1.

Washers (qty 2) 2. Nuts (qty 2) 3. Frame Rail 4. Fuel Outlet Port 5. Fuel Inlet Port 6. Priming Pump 7. Mounting Head 8. Mounting Bolts (qty 2) 9. Filter Element 10. Sight Bowl 11. Drain Plug 4.1 Place a suitable container under the fuel/ water separator. Fig. 23.13, Alliance Fuel/Water Separator Assembly and Installation NOTE: A hose may be used to direct water into the container. Use a hose with a Ѕ-inch pipe thread on DAVCO models. 4.4 Stop draining fluid when fuel begins to drain out. 4.2 If the engine is equipped with a built-in water separator, loosen the drain valve, and allow the water to run out. Close the drain valve, taking care not to overtighten it. Alliance/Racor Models :

turn the drain plug clockwise to close it. DAVCO Models : close the drain valve. Install and hand-tighten the vent cap. ConMet Models : close and tighten the valve finger-tight. 4.3 Alliance/Racor Models : Turn the drain plug counterclockwise to open it. See Fig. 23.13 . 5. Inspect the steering components. 23.10