Pre- and Post-Trip Inspections and Maintenance 10 9 8 7 6 5 11/30/95 f470167 Fig. 23.15, ConMet Fuel/Water Separator 5.1 Inspect tie rods, steering arms, and the drag link for signs of looseness (i.e., shiny spots or rust tracks). 4 5.2 Check the steering gear mounting bolts and pitman arm nut for signs of loose- ness. 11 5.3 Check the drag link nuts for missing cotter pins. 3 12 5.4 Inspect the steering intermediate shaft and end yokes for excessive looseness or other damage. 2 NOTICE Do not drive with a drive belt that is visibly worn or damaged. If it fails, the lack of coolant flow could rapidly cause damage to engine compo- nents. 1 13 05/05/2009 f470530 1. Inlet Port/Check Valve 2.
Lower Housing 3. Bypass Valve 4. Filter Element 5. Spring 6. Cover O-Ring 7. Clear Cover 8. Vent Cap O-Ring 9. Vent Cap 10. Collar 11. 120VAC Pre-Heater 12. 12VDC Pre-Heater 13. Drain Valve 6. Inspect the serpentine drive belts for signs of glazing, frayed edges, breaks, cracks, or oil con- tamination. Fig. 23.14, DAVCO Fuel/Water Separator (Fuel Pro 482 shown) 23.11