Pre- and Post-Trip Inspections and Maintenance Monthly Post-Trip Inspections and Maintenance Brake Component Inspection NOTICE If the water drained from the air reservoirs is cloudy or oily, it may indicate a problem with the compressor. If oil is allowed to contaminate the air dryer, it will not remove the water from the air brake system, which could adversely affect brak- ing. Walk around the vehicle and visually the brake sys- tem components for visible damage. 1. Inspect all visible brake system components for missing fasteners or signs of looseness, such as rust tracks. 1. Drain the brake system air reservoirs (reservoirs with automatic drain valves only). NOTICE NOTE:
Battery locations vary between vehicles. 2. Inspect the batteries. If the external breather tube or breather cap is missing or incorrectly installed, road dirt and de- bris can adversely affect the operation of the brake chamber. Once inside of the chamber, dirt and debris can cause the internal parts of the chamber to deteriorate faster. WARNING Battery posts, terminals, and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. To prevent possible per- sonal injury, always wash your hands after han- dling battery parts and related accessories. 2. Inspect the exterior surfaces of brake chambers for damage.
Make sure that breather holes are open and free of debris. NOTE: Do not route air brake lines on top of anything likely to be stepped on. 2.1 Remove the battery box cover and inspect all visible battery cables for loose wiring or damage. 3. Inspect air brake lines for dents, swelling, kinks, twisting, abrasion, and damage, especially near moving parts. 2.2 Check that the battery hold-down is se- cure. 4. Inspect flex air hoses for deterioration or signs of abrasion. IMPORTANT: Aerodynamic components de- crease drag force as a vehicle moves, thereby improving fuel efficiency.
If replacement of an aerodynamic component is necessary, replace- ment components must meet or exceed the drag reduction performance of the originally in- stalled component in order to maintain compli- ance with greenhouse gas and full efficiency regulations (GHG14). 5. Inspect for cracked, worn, or oil-contaminated brake linings and brake drums (or rotors). 6. Check the thickness of the brake linings. Re- place brake linings on all brake assemblies on the axle if any brake linings are worn to less than approximately 1/4 inch (6.4 mm) at the thinnest point. 3. Inspect the following aerodynamic components, if equipped, for structural damage, cracks, or wear.
Saddle Tank Areas Inspection WARNING Chassis fairings When draining the air reservoir, do not look into the air jets or direct them toward anyone. Dirt or sludge particles may be in the airstream and could cause injury. Roof fairing/deflector Side skirts Cab/sleeper extenders Battery access cover 23.12