Western Star — Western Star (EN)

Pre- and Post-Trip Inspections and Maintenance Engine Compartment Inspection and Adjustments 4.1 Start the engine. With the front tires straight ahead, turn the steering wheel until motion is observed at the front wheels. IMPORTANT: If replacement of the hood or bumper is necessary, the replacement compo- nent must meet or exceed the drag reduction performance of the originally installed item in order to maintain compliance with greenhouse gas and full efficiency regulations (GHG14). 4.2 Align a reference mark on the steering wheel to a rule, then slowly turn the steer- ing wheel in the opposite direction until motion is again detected at the wheels.

4.3 Measure the lash (free play) at the rim of the steering wheel. Excessive lash exists if steering wheel movement exceeds 2-1/2 inches (64 mm) with a 20-inch (508-mm) steering wheel, or 2-1/4 inches (57 mm) with an 18-inch (450-mm) steering wheel. 1. Inspect the bumper and hood for structural dam- age, cracks, or wear. 2. Check the hydraulic clutch reservoir, if equipped. If necessary, add DOT 4 brake fluid. 3. Inspect the radiator and heater hoses, including the clamps and support brackets. 4.4 If there is excessive lash, check the steer- ing system for wear or incorrect adjust- ment before operating the vehicle.

3.1 Inspect the radiator and charge air cooler for damage and accumulated debris. Straighten bent or damaged fins to permit airflow across all areas of the cores. NOTE: When traveling through areas of high insect concentration, it may be necessary to clean the exterior of the radiator or the charge air cooler core as often as every 200 miles (320 km). 3.2 Make sure the radiator inlet and outlet hoses are pliable and are not cracking or ballooning. 3.3 Make sure the heater hoses are pliable and are not cracking or ballooning. 3.4 Tighten hose clamps as necessary. IMPORTANT: Do not overtighten hose clamps, as hose life can be adversely af- fected.

3.5 Ensure hose support brackets are se- curely fastened. Make sure hoses are not located near sources of wear, abrasion, or high heat. IMPORTANT: When replacing hoses, install service-type knitted or braided yarn-reinforced neoprene hose. Extended-service-life silicone hoses may also be used. See the Alliance Parts Catalog at www.alliancebrandparts.com or contact your Freightliner Dealer. 4. Check the steering wheel for excessive play. 23.13