Climate Controls 2 3 4 5 6 PM ON 1 ALARM TIME OFF 7 SET − DISP SET + AUTO Automatic Temperature Control 01/14/2003 8 9 10 f610629 1. Alarm Button 2. Time Button 3. Fan Up Button 4. Heater and Air Conditioner On Button 5. Heater and Air Conditioner Off Button 6. Temperature Up Button 7. Temperature Down Button 8. Automatic Fan Button 9. Fan Down Button 10. Display Button Fig. 5.5, Sleeper Climate Control Panel With ATC least two seconds to continuously increase or de- crease the fan speed. The fan speed setting is dis- played on the sleeper control panel in 10 percent increments. When the highest or lowest fan speed is selected, HI or LO is displayed.
The display returns to the time display five seconds after a fan up/down button is pressed and released. perature. The temperature setting is displayed on the sleeper control panel. The display returns to the time display five seconds after a temperature up/down button is pressed and released. The temperature units can be changed from °F to °C or from °C to °F by pressing the temperature up and temperature down buttons simultaneously. Changing the temperature units on the ATC sleeper control panel will also change the temperature units on the ATC cab control panel. In the ATC mode, fan speed is determined by the system as required.
The fan speed is based on the difference between the set point temperature and the actual sleeper cab temperature. The greater the dif- ference, the greater the fan speed. The AUTO fan function is disabled when either the fan up or fan down button is pressed. Auto Button Press the AUTO button to enable automatic control of the fan speed. The display will show the current set temperature for five seconds, then return to the time display. When in the automatic mode, the fan speed can vary to maintain the temperature set by the user. When automatic control is turned on, the indicator above the AUTO button illuminates.
Temperature Control Switch Temperature is displayed with a three-digit annotation and can be displayed either in degrees Celsius or degrees Fahrenheit. A capital "C" or "F" is displayed for the appropriate temperature scale. To select the desired temperature, press the tem- perature up or temperature down button repeatedly to incrementally increase or decrease the set tem- perature. Press either button for at least two seconds to continuously increase or decrease the set tem- Alarm Button Momentarily press the ALARM button to turn the alarm on and to illuminate the alarm indicator above the ALARM button. Momentarily press the button again to deactivate the alarm. 5.5