Western Star — Western Star (EN)

Climate Controls When pressing the ALARM button, the display shows the alarm time setting for five seconds before return- ing to the current time display. If the ALARM button is pressed and held down continuously for more than one second, the alarm time setting can be viewed without changing the state of the alarm indicator. If either the SET+ or SET– buttons are pressed simul- taneously with the ALARM button held down, the alarm time setting will increase or decrease. When the ALARM button is released after changing the alarm time, the alarm will be turned on and the indi- cator will be illuminated.

When the ALARM is sound- ing, press the ALARM button to turn the alarm off and to reset the alarm for the next 24-hour cycle. be off. All clock functions, including the alarm, will continue to work internally. Temperature Slave Mode Feature The temperature slave mode allows the set tempera- ture of the cab heater and air conditioner to be auto- matically tied to the sleeper heater and air condi- tioner. In this mode, the set temperature in the vehicle will be the same whether the set temperature is changed on the cab climate control panel or the sleeper climate control panel. To enable the tempera- ture slave mode, press the SET+ and SET– buttons simultaneously.

The display will read S–ON when the temperature slave mode is enabled. To set the snooze function, press any button on the control panel, except the ALARM button, when the alarm is sounding. The alarm will sound again after seven minutes. The alarm indicator flashes when the snooze function is set. To disable the temperature slave mode, press the SET+ and SET– buttons simultaneously. The display will read S–OFF indicating that the temperature slave mode is disabled. When disabled, the temperatures for the cab and sleeper can be changed indepen- dently for separate temperature control.

If you wish to maintain a temperature in the sleeper that is differ- ent than the temperature in the front of the cab, it is recommended that a curtain be used between the sleeper and the front of the cab. To cancel the snooze function, press the ALARM but- ton. This will also reset the alarm for the next 24- hour cycle. Time Button The clock controls are located on the left side of the ATC sleeper control panel under the display. The dis- play will show the clock time as the default mode. Turning on the Sleeper Air Conditioner When the Cab Air Conditioner is Off Press the TIME button to display the current time.

If the TIME button is held down and either the SET+ or SET– buttons are pressed simultaneously with the TIME button, the clock setting will increase or de- crease. The sleeper ATC control panel can turn on the air conditioner even if the cab HVAC unit is turned off but the engine is running. By pressing the ON button, the ATC sleeper control panel will turn on the cab unit and the bunk indicator light on the cab control panel will be illuminated. If cooling is needed in the sleeper, the cab HVAC unit will switch on to a low blower fan setting and the A/C compressor clutch will engage.

If cooling is no longer required in the sleeper or if heat is needed, the cab unit fan and the compressor clutch will be turned off after a five- minute delay. Display Button Press the DISP button to allow the display and illumi- nation of the control panel to scroll through three illu- mination levels: bright, dim, and off. If you want the alarm, time, or temperature setting to be displayed when the display is in the off mode, press the ALARM, TIME, or temperature up/down buttons to display the corresponding display for five seconds. After five seconds, the display will turn off. If the alarm sounds while in the display off mode, the cur- rent time will be displayed simultaneously.

The dis- play will remain on for five minutes, then turn off. Accessory Heaters Optional accessary heaters are available from the factory in several configurations. Familiarize yourself with the equipment on your specific vehicle, and fol- low the manufacturer’s operating and maintenance instructions. When the vehicle ignition is not powered, the sleeper climate control panel is in a power-saving mode and the display and illumination of the control panel will 5.6