Seats and Restraints WARNING Inspect the seat belts and tether belts (if so equipped). 1. Check the web for fraying, cuts, extreme dirt and dust, or for severe fading from exposure to sun- light, especially near the buckle latch plate and in the D-loop guide area. Always use the vehicle’s seat belt system when operating the vehicle. Failure to do so can result in severe personal injury or death. Seat belt assemblies in DTNA vehicles meet Federal Motor Vehicle Safety Standard 209, "Type 1" and "Type 2" requirements. 2. Check operation of the buckle, latch, Komfort Latch or Sliding Komfort Latch (if equipped), web retractor, and upper seat belt mount on the door pillar.
Check all visible components for wear or damage. When transporting a child, always use a child re- straint system or the vehicle seat belts as appropri- ate. To determine whether a child restraint system is required, review and comply with applicable state and local laws. Any child restraint used must comply with Federal Motor Vehicle Safety Standard 213, "Child Restraint Systems." When providing a child restraint system, always carefully read and follow all instructions pertaining to installation and usage for the child. Make certain the child remains in the re- straint system at all times when the vehicle is in motion. 3.
Check the seat belt and tether belt connection points and tighten any that are loose. Seat Belt Operation Seat Belt With Komfort Latch or Sliding Komfort Latch NOTE: For vehicles not equipped with the Kom- fort Latch or the Sliding Komfort Latch, see the seat belt operation under the heading Three- Point Seat Belt . In addition to seat belt assemblies, tether belts are installed on suspension-type seats. Tether belts help secure the seat to the floor and are intended to re- strain the seat and seat belt in case of an accident or sudden stop. WARNING IMPORTANT: Seat belts have a finite life which may be much shorter than the life of the vehicle.
Regular inspections and replacement as needed are the only assurance of adequate seat belt security over the life of the vehicle. Wear three-point seat belts only as described below. Three-point seat belts are designed to be worn by one person at a time. In case of an acci- dent or sudden stop, personal injury or death could result from misuse. Fasten the seat belts before driving. Fastening a three-point seat belt while driving creates a haz- ard. Seat Belt Inspection WARNING When engaged and used properly, the Komfort Latch ( Fig. 6.6 ) and the Sliding Komfort Latch ( Fig. 6.7 ) introduce a small amount of slack into the seat belt, resulting in a more comfortable ride.
Inspect and maintain seat belts. When any part of a seat belt system needs replacement, the entire seat belt must be replaced, both retractor and buckle side. Any time a vehicle is involved in an accident, and the seat belt system was in use, the entire vehicle seat belt system must be re- placed before operating the vehicle. Do not at- tempt to modify the seat belt system; doing so could change the effectiveness of the system. Failure to replace worn or damaged seat belts, or making any modifications to the system, may re- sult in personal injury or death. 1.
Slowly pull the link end of the seat belt out of the retractor and pull it across your lap (from out- board to inboard) far enough to engage the buckle. If the retractor locks too soon, allow the belt to retract slightly, then slowly pull it out again. 2. Fasten the seat belt by pushing the latch into the buckle. Listen for an audible click. See Fig. 6.8 . 3. Tug on the seat belt to make sure it is securely fastened. If the buckle unlatches, repeat this 6.6