Seats and Restraints A B 01/18/95 f910004a Fig. 6.8, Fastening the Three-Point Belt 03/11/2010 f910620 WARNING A. Disengaged B. Engaged Fig. 6.6, Komfort Latch Before activating the Komfort Latch or the Slid- ing Komfort Latch, make sure the amount of slack in the shoulder strap is set as described below. Excess slack in the shoulder strap re- duces the effectiveness of the seat belt, and in- creases the risk of injury or death in an accident. 5. Position the shoulder strap diagonally across your chest with the adjustable D-loop bracket (if equipped). The shoulder strap must be centered on your shoulder and chest, away from your face and neck. See Fig. 6.9 .
If desired, engage the Komfort Latch or Sliding Komfort Latch as fol- lows. If equipped with a Sliding Komfort Latch, make sure that the shoulder strap is snug against your chest. Without loosening the shoulder strap, push the Sliding Komfort Latch switch to the "ON" position. See Fig. 6.7 . To activate the latch lean forward until you hear a click. This will allow for approximately 1 inch (2.5 cm) of slack be- tween your chest and the shoulder harness. Once engaged, the latch will allow you to lean forward about 5 inches (13 cm) without having to reset the latch. Leaning forward more than 5 inches (13 cm) will disengage the Sliding Kom- fort Latch, requiring it to be reset.
11/18/2010 f910621a Fig. 6.7, Sliding Komfort Latch step. If the problem continues, replace the seat belt. 4. Snug the seat belt to your waist. If equipped with a Komfort Latch, pull on the shoulder strap to lessen the pressure of the strap 6.7