Western Star — Western Star (EN)

Optional Engine Systems Engine Protection—Warning and Shutdown Do not operate the vehicle further until the problem causing the shutdown has been corrected. The driver should be familiar with the vehicle warning system in order to bring the vehicle to a safe stop if the engine malfunctions. If the driver doesn’t under- stand how the warning system works, an engine shutdown could occur. CHECK STOP The engine will begin a warning and shutdown pro- cess if the engine coolant temperature, coolant level, engine oil pressure, or exhaust aftertreatment system (ATS) reach preset levels.

On some engines, the en- gine will also begin the warning and shutdown pro- cess when the engine oil temperature or the intake air temperature reach preset levels. Detroit Diesel engines will begin the warning and shutdown process if water is detected in the fuel. 07/09/2009 f611036 1 2 3 1. Malfunction Indicator Lamp (MIL) 2. CHECK Engine Lamp 3. STOP Engine Lamp Fig. 10.1, Engine Warning Lights Some vehicles may have a shutdown-override switch, which can be used to momentarily override the shutdown sequence. This switch resets the shut- down timer, restoring power to the level before the derate for another 30 or 60 seconds (depending on the critical fault type).

The switch must be pressed again after five seconds to obtain a subsequent override. See the engine manufacturer’s operation manual for specific details for your vehicle. See Chapter 11 for the warning and shutdown modes associated with the ATS. Electronic engine protection is programmable as an option, and can be specified as one of the following modes: DERATE and SHUTDOWN (factory default), WARNING, or OFF. In WARNING mode, the amber CHECK engine lamp will flash and a buzzer will sound. The engine elec- tronics log the event for diagnostic purposes. The CHECK engine lamp will go out if the problem stops.

WARNING In OFF mode, the individual sensor indicator lamps will illuminate if a problem exists, but no shutdown action will be started and the event will not be re- corded. When the red STOP engine or engine protection light illuminates, most engines are programmed to shut down automatically within 30 seconds. The driver must immediately move the vehicle to a safe location at the side of the road to prevent causing a hazardous situation that could cause bodily injury, property damage, or severe damage to the engine. Engine Idle Limiting Idle Shutdown Timer This feature is an optional 1- to 100-minute idle shut- down system.

Its purpose is to conserve fuel by eliminating excessive idling and allowing a turbo- charger cool-down period. Idle shutdown timing and parameters are programmable. See the engine manufacturer’s operation manual for specific details for your vehicle. In DERATE and SHUTDOWN mode, the red STOP engine lamp will illuminate when the problem is seri- ous enough to reduce power or speed. See Fig. 10.1 . Engine power will ramp down, then the engine will shut down if the problem continues. The driver has 30 or 60 seconds (depending on the criti- cal fault type) after the STOP engine lamp illumi- nates to move the vehicle safely off the road.

If the vehicle cannot be moved to a safe location within that time, the engine can be restarted by turning the ignition switch OFF for at least five seconds, then back ON. Repeat this action until the vehicle is safely off the road. California Engine Idle Limit In order to meet the California Air Resources Board (CARB) engine idle limiting standard, vehicles are equipped with an engine idle shutdown feature. The automatic shutdown feature is required on all 10.1