Western Star — Western Star (EN)

Optional Engine Systems California-certified engines (with the exception of en- gines used in specific vehicle types that are exempt from the requirement). Owners that wish to have the shutdown feature disabled on vehicles operating in California should consult with California authorities to determine if their vehicle qualifies for the exemption. When the CARB engine idle limiting feature is en- abled, the engine will typically shut down after five minutes of continuous idling when the transmission is in neutral and the parking brake is set. It will also shut down after 15 minutes when the transmission is in neutral, with the parking brake off.

See the engine manufacturer’s operation manual for specific details for your vehicle. CRUISE CONTROL SET/DECEL RES/ACCEL After an automatic shutdown, the engine may be re- started and operated normally. 07/15/2011 f545790 Fig. 10.2, Cruise Control Switches Activating or momentarily changing the position of the brake pedal, clutch pedal, accelerator pedal, shutdown override switch, or parking brake during the final 30 seconds will cause the shutdown timer to reset. Cruise at a particular speed 1. Press the upper part of the cruise control on/off switch to turn cruise control on. 2. Hold the accelerator pedal down until the speed- ometer reaches the desired speed. Cruise Control NOTE:

Cruise control is cancelled if the brake or clutch pedal is depressed, or engine speed drops below 1200 rpm. WARNING Do not use the cruise control system when driv- ing conditions do not permit maintaining a con- stant speed, such as in heavy traffic or on roads that are winding, icy, snow-covered, slippery, or roads with a loose driving surface. Failure to fol- low this precaution could cause a collision or loss of vehicle control, possibly resulting in per- sonal injury or property damage. 3. Press the upper half of the Set/Resume/ Accelerate/Decelerate switch momentarily to set the cruise speed (with the vehicle moving at the desired speed).

To decrease cruise speed, press and hold the upper half of the Set/Resume/Accelerate/ Decelerate switch to decelerate slowly. Release the switch when the desired speed is achieved. NOTICE To increase cruise speed, press and hold the lower half of the Set/Resume/Accelerate/ Decelerate switch to accelerate slowly. Release the switch when the desired speed is achieved. When the cruise control is engaged, do not at- tempt to shift gears without using the clutch pedal. Failure to follow this precaution will result in a temporarily uncontrolled increase in engine speed. Transmission damage and gear stripping could result. Disengage cruise control NOTE:

The speed memory is lost whenever the ignition is turned off or the cruise control system is turned off. Cruise control is activated by two dash-mounted switches: an on/off switch (CRUISE CONTROL) and a Set/Decelerate/Resume/Accelerate switch. See Fig. 10.2 . 1. Depress the brake pedal (automatic or manual transmissions) or 10.2