Optional Engine Systems Depress the clutch pedal (manual transmissions only). property damage. Service brakes are the primary vehicle braking system. NOTE: To resume the preselected cruise speed, increase vehicle speed to above minimum cruise control speed and momentarily press the lower half of the Set/Resume/Accelerate/ Decelerate switch. Cruise will return to the last speed selected. Two dash-mounted switches ( Fig. 10.3 ) control the engine brake: The on/off switch (ENGINE BRAKE), is used to turn the engine brake on and off. The engine brake intensity switch (HIGH/MED/ LOW or, in some cases, HIGH/LOW) controls the amount of engine braking.
When the en- gine brake is on, a status bar illuminates on the intensity switch, indicating the current set- ting. 2. Press the lower half of the on/off switch. Auxiliary Braking Applications Engine Brake Since the engine brake is most effective at rated en- gine speed, gear selection is very important. Gearing down the vehicle within the limits of the rated engine speed makes the engine brake more effective. Rec- ommended engine braking speed is above 1800 rpm and below the rated speed. Each engine manufacturer uses a specific engine brake for their engine. Regardless of the manufac- turer, the engine brake is operated with the principles outlined in this chapter.
Refer to the engine manufac- turer’s operation manual for details of their particular engine brake product. WARNING To avoid injury from loss of vehicle control, do not activate the engine brake system under the following conditions: M ENGINE BRAKE HIGH MED LOW on wet or slippery pavement, unless the vehicle is equipped with antilock braking system (ABS) and you have had prior expe- rience driving under these conditions; when driving without a trailer or pulling an empty trailer; if the tractor drive wheels begin to lock, or there is fishtail motion after the engine brake is activated. 07/15/2011 f545791 Fig.
10.3, Engine Brake Switches Whenever vehicle braking is required on good road conditions, the engine brake may be used in con- junction with the service brakes. There is no time limit for operation of the engine brake. However, an engine brake does not provide the precise control of, and is not a substitute for, service brakes. WARNING The engine brake must be disengaged when shifting gears using the clutch pedal. If the en- gine brake is engaged when the transmission is in neutral, the braking power of the engine brake can stall the engine, which could result in loss of vehicle control, possibly causing personal injury and property damage.
WARNING Usage of the engine brake as the primary braking system can cause unpredictable stopping dis- tances, that could result in personal injury or "Control speed" is the speed at which the engine brake performs 100 percent of the required downhill braking, resulting in a constant speed of descent. 10.3