Western Star — Western Star (EN)

Optional Engine Systems The control speed varies, depending on vehicle weight and the downhill grade. dash switch to maintain constant speed of de- scent. Grade descent speed should be such that the service brakes are used infrequently and re- main cool, thus retaining their effectiveness. For faster descent, select a higher gear than that used for control speed. Service brakes must then be used intermittently to prevent engine overspeed and to maintain desired vehicle speed. 4. For maximum retarding, maintain the top gov- erned speed of the engine through the appropri- ate selection of gears.

When shifting gears, the engine brake will disengage when the clutch pedal is depressed, then engage when the clutch pedal is released. For slower descent, select a lower gear, being care- ful not to overspeed the engine. Occasional deactiva- tion of the engine brake may be necessary to main- tain the designated road speed under these conditions. 5. To cancel the engine brake application, press the lower half of the on/off switch. If the engine is equipped with both cruise control and an engine brake, the engine brake can operate auto- matically while cruise control is activated. The maxi- mum amount of braking is selected with the dash switches.

When the vehicle returns to the set cruise speed, the engine brake will turn off. Exhaust Brake An exhaust brake is an optional auxiliary braking sys- tem that assists but does not replace the service brake system on vehicles with Cummins engines. Exhaust brakes are not intended for use as the pri- mary braking system during vehicle operation. The engine brake will only operate when the accel- erator and clutch pedals are fully released. Vehicles equipped with ABS have the ability to turn the engine brake off if wheel slip is detected. The engine brake will automatically turn back on once wheel slip is no longer detected. The exhaust brake is controlled by a dash-mounted rocker switch.

See Fig. 10.4 . Engine Brake Operation Depending on the brake type, the engine brake may be disabled when engine temperature falls below a set level. ENGINE BRAKE NOTICE Do not allow the engine to exceed its governed speed, or serious engine damage could result. To operate the engine brake after the engine is warmed up and the vehicle is in motion: 07/18/2011 f545792 1. Remove your feet from both the clutch and ac- celerator pedals. Fig. 10.4, Exhaust Brake Switch 2. Press the upper half of the on/off switch to turn the engine brake on. The engine brake will en- gage at the rate last set on the engine brake in- tensity switch. To turn the exhaust brake on, press the upper half of the switch.

The exhaust brake turns itself off automatically. In addition, depressing the accelerator or clutch pedal deactivates the exhaust brake. The ABS, when ac- tive, also deactivates the exhaust brake. 3. Press the upper or lower half of the intensity switch to select the desired braking intensity. Use the intensity switch set at the LOW position when driving on flat, open stretches of road. If the service brakes are still required to slow down on a grade, switch to a higher setting on the 10.4