Western Star — Western Star (EN)

Optional Engine Systems Exhaust Brake Operation The exhaust brake retards the vehicle with a smooth braking effect. WARNING During a descent, the tachometer usually shows a drop in rpm, depending on the grade and the vehicle load. Do not use the exhaust brake when driving on slippery or low-traction road surfaces. Failure to follow this precaution could result in a loss of vehicle control and possible personal injury or property damage. Depending on the grade and vehicle load, the retarding force of the exhaust brake may be noticeable. 5. Apply the service brakes to reduce engine rpm or make a slower descent by using a lower gear. 1.

Before starting the engine, make sure that the exhaust brake is off. Wait until the engine has reached normal operating temperature before activating the exhaust brake. 6. Make sure the exhaust brake is turned off before shutting down the engine. 2. When approaching a downhill grade, press the upper half of the exhaust brake switch to turn the exhaust brake on. When the exhaust brake is on, the status bar is illuminated. Power Takeoff (PTO) Governor Engine power takeoffs (PTO) are devices used to tap into engine power to run auxiliary devices, such as hydraulic pumps that power additional equipment. The following are general guidelines for operating a PTO. 3.

Remove your feet from the accelerator and clutch pedals. NOTICE Do not allow the engine to exceed its governed speed, or serious engine damage could result. Set the parking brake and put the transmission in neutral. Press the upper half of the PTO switch. When the status bar light is steadily illuminated, the PTO is engaged and ready to operate. In sta- tionary mode, the vehicle must remain in neu- tral with the parking brake set. NOTE: The exhaust brake is only active when engine speed is between 1100 and 2700 rpm. 4. While going down a grade, use a low enough gear to safely descend with a minimum applica- tion of the service brakes.

As a general guide- line, use the same gear as you would to ascend the hill. To activate the mobile mode, shift from neutral to reverse, 1st, or 2nd gear. The clutch will open and the PTO will disengage for a mo- ment. The following conditions should exist if the brake is operating properly: Touch the accelerator pedal to close the clutch and engage the PTO in mobile mode. The PTO may be operated with the transmission in neutral or reverse, 1st, or 2nd gears only. Do not attempt to change gears while the vehicle is moving. The transmission will ignore the re- quest. A slight change in the sound of the engine may be noticeable. Exhaust smoke should appear normal.

Engine temperature should remain in the normal operating range. Road speed will usually decrease when the exhaust brake is applied during a descent. When the vehicle is carrying a heavy load or the grade is extremely steep, you may need to apply the service brakes occasion- ally. To deactivate mobile mode, bring the vehicle to a stop. The clutch will open and shut down power to the PTO. To resume stationary mode, shift to neutral. The PTO will engage. To deactivate stationary mode, press the lower half of the PTO switch. When the light in the switch goes out, power to the PTO is shut off. 10.5