Western Star — Western Star (EN)

Brake Systems Air Brake System General Information, Brake System the rear brake chambers (on which the axle load has been greatly reduced) receive reduced (proportional) air pressure, while the front axle brake chambers receive full (normal) air pres- sure. This results in a different brake pedal "feel," as the pedal seems to require more travel and/or effort to slow or stop the vehicle. How- ever, the air brake proportioning system actually improves vehicle control when the tractor is in bobtail mode. When the tractor is towing a trailer, the rear brake chambers will receive full (normal) application air pressure.

A dual air brake system consists of two independent air systems that use a single set of brake controls. Each system has its own reservoirs, plumbing, and brake chambers. The primary system operates the service brakes on the rear axle; the secondary sys- tem operates the service brakes on the front axle. Service brake signals from both systems are sent to the trailer. Brake System Operation WARNING NOTE: If equipped with main and auxiliary transmissions, do not shift both transmissions into neutral while the vehicle is rolling. Shifting both transmissions back into gear would be diffi- cult while the vehicle is rolling.

Do not operate the vehicle with the front brakes backed off or disconnected. Backing off or dis- connecting the front brakes will not improve ve- hicle handling and may lead to loss of vehicle control, resulting in property damage or personal injury. On tractor-trailer vehicles, if both the primary and secondary systems become inoperative, the trailer service brakes or spring parking brakes will automati- cally apply when air pressure drops below 35 to 45 psi (241 to 310 kPa). The tractor spring parking brakes will automatically apply when air pressure drops below 20 to 30 psi (138 to 207 kPa).

On straight trucks, spring parking brakes will apply when air pressure drops below 20 to 30 psi (138 to 207 kPa). Do not wait for the brakes to apply automati- cally. When the warning light and buzzer first come on, immediately bring the vehicle to a safe stop. Be- fore continuing operation of the vehicle, correct the cause of the air loss. Before driving your vehicle, allow time for the air compressor to build up a minimum of 100 psi (690 kPa) pressure in both the primary and secondary systems. Monitor the air pressure system by observ- ing the dual system air pressure gauge and the low- air-pressure warning light and buzzer.

The warning light and buzzer shut off when air pressure in both systems reaches 64 to 76 psi (441 to 524 kPa). IMPORTANT: Before driving the vehicle, secure all loose items in the cab so that they will not fly forward during a full brake application. Make sure all passengers are wearing seat belts. WARNING During normal brake stops, depress the foot brake control pedal until braking action slows down the ve- hicle. Increase or decrease the pressure on the pedal so that the vehicle comes to a smooth, safe stop. Apply the spring parking brakes if the vehicle is to be parked.

If a trailer or combination vehicle is not equipped with spring parking brakes, do not park it by pull- ing out only the trailer air supply valve knob. This would apply only the trailer service brakes. If air were to bleed from the trailer brake system, the trailer brakes would release, possibly causing an unattended runaway vehicle. When parking a vehicle attached to a trailer that does not have spring parking brakes, apply the trac- tor parking brakes. Chock the trailer tires before dis- connecting the vehicle from the trailer. WARNING IMPORTANT: An air brake proportioning system may be used in tractor air brake systems when the vehicle is not equipped with antilock braking system (ABS).

When operating in bobtail mode, Do not use the trailer service brakes for parking; they are not designed for this purpose. If air bleeds out of the trailer air tank during parking, the vehicle could roll, causing serious personal injury or property damage. 12.1