Brake Systems NOTICE 5 Never apply the service and spring parking brakes simultaneously. To do so transmits exces- sive input force to the brake components, which could damage or cause eventual failure of brake actuating components. 6 Do not use the spring parking brakes if the ser- vice brakes are hot, such as after descending a steep grade. To do so could damage the brakes. Allow hot brakes to cool before using the spring parking brakes. Do not use the spring parking brakes during freezing temperatures if the service brakes are wet. To do so could cause them to freeze. If the brakes are wet, drive the vehicle in low gear and lightly apply the brakes to heat and dry them.
4 05/07/2001 f610493 1 2 3 Brake Controls 1. Tilt/Telescopic Steering Column Lever 2. Four-Way Hazard Flasher 3. Turn Signal Lever 4. Headlight Dimmer Switch 5. Electric Horn 6. Trailer Brake Control Lever The trailer brake lever is used for applying the trailer brakes without applying the truck or tractor service brakes. It is usually mounted on the steering column. See Fig. 12.1 . The valve can be partially or fully ap- plied, but in any partially on position it will be overrid- den by a full application of the service brake pedal. Moving the lever clockwise (down) applies the trailer brakes, while moving it counterclockwise (up) re- leases the trailer brakes.
The lever will remain in the selected position until it is manually moved. Fig. 12.1, Trailer Brake Control Lever 1 2 The red octagonal-shaped knob actuates the trailer air supply valve. See Fig. 12.2 . After the vehicle’s air hoses are connected to a trailer and the pressure in both air systems is at least 65 psi (448 kPa), the trailer air supply valve must be pushed in. It should stay in to charge the trailer air supply system and to release the trailer spring parking brakes. 03/10/99 f610291 1. Trailer Air-Supply-Valve Knob 2. Parking-Brake-Valve Knob Pull the trailer air supply valve out before disconnect- ing a trailer or when operating a vehicle without a trailer.
If pressure in both air systems drops to 35 to 45 psi (241 to 310 kPa), the trailer air supply valve automatically pops out, exhausting the trailer air sup- ply, and applying the trailer service or spring parking brakes. Fig. 12.2, Brake Valve Knobs If the trailer is not equipped with spring parking brakes, pulling out the parking brake valve applies the tractor spring parking brakes and the trailer ser- vice brakes. When the tractor and trailer parking brakes (or trailer service brakes) are both applied, the trailer brakes are released by pushing in the trailer air supply valve, leaving the tractor parking brakes applied.
Air pressure in the primary or sec- ondary reservoir must be at least 65 psi (448 kPa) The yellow diamond-shaped knob actuates the park- ing brake valve. See Fig. 12.2 . Pulling out the park- ing brake valve applies both the tractor and trailer spring parking brakes and automatically causes the trailer air supply valve to pop out. 12.2