Brake Systems the switch will temporarily allow more drive wheel spin. Pressing the switch again will cycle the system back to normal operation. warning lights go out if all of the tractor’s ABS com- ponents are working. IMPORTANT: If any of the ABS warning lights do not work as described above, or come on while driving, repair the ABS immediately to en- sure full antilock braking capability. Roll-Stability Control The roll-stability control system automatically reduces engine power, applies the engine brake, and/or ap- plies the tractor and trailer brakes when the accelera- tion sensor detects that the vehicle is at risk of rolling over.
The control can intervene even before an advi- sory message is displayed. A decal ( Fig. 12.5 ) on the auxiliary dash panel, and an amber-colored dash indicator light ( Fig. 12.6 ), in- dicate that the vehicle is equipped with the roll- stability system components. 05/15/2001 f610494 Fig. 12.4, Deep Mud and Snow Switch The dash indicator light illuminates whenever the roll- stability control system intervenes. See Fig. 12.6 . An additional solenoid valve is installed.
During reduced-traction situations, the ATC solenoid valve controls air pressure to the modulator valves and they in turn increase, hold, or reduce pressure to the appropriate brake chambers to provide better traction whenever wheel spin occurs. NOTE: The roll-stability control indicator is lo- cated on the lightbar in place of the standard WHEEL SPIN indicator. When the ATC system is in the NORMAL mode, it will apply gentle braking to the spinning wheel, to feed power to the wheel(s) with better traction. If both wheels are spinning, the system will signal the engine to reduce power. SAFETY INSTRUCTIONS lamp indicates traction OR roll control event. Follow instructions in driver’s manual.
NOTICE 07/11/2003 f080125 24−01204−000 The deep snow and mud option is intended to be used under specific slippery conditions that re- quire momentary increased wheel spin. Using this option for an extended period of time may damage the vehicle brake system. Fig. 12.5, Roll-Stability Decal WARNING ATC includes a deep snow and mud option to in- crease available traction on extra soft surfaces like snow, mud, or gravel. The activation of the deep snow and mud option is indicated by a flashing WHEEL SPIN lamp. The Roll Stability Control system is intended only as an aid for a conscientious and alert driver.
Carefully read the information in this manual to understand this system and its limitations. The Roll Stability Control system is not a substitute for safe driving procedures. Failure to drive safely, and use the system properly, could result in personal injury and/or death and property damage. After the ignition switch is turned on, the tractor ABS lamp and the WHEEL SPIN indicator lamp come on for about three seconds. After three seconds, the 12.5