Doosan DX225LC-3 — 20. Power Socket for 12 Volt (Optional)

18. Fuel Heater Switch (Optional) This switch is used to activate the fuel heater system. When the switch is activated, the fuel is warmed, depending upon the temperature of the fuel. O I NOTE: If the fuel temperature is above 5°C (41°F), heating system is not activated. O. In this position, the fuel heater system is turned "OFF". I. In this position, the fuel heater system is turned "ON". FG016024 NOTE: The starter switch must be "ON". Figure 28 19. Overload Warning Switch (Optional) If unit is equipped with an overload warning device, push this switch to activate it. O I O. In this position, the overload warning device is turned "OFF". I.

In this position, the overload warning device is turned "ON". When a load is lifted that reaches the machine’s lifting limit, the warning symbol on the display monitor will turn "ON" and a warning buzzer will sound. Figure 29 FG016023 WARNING AVOID DEATH OR SERIOUS INJURY To prevent injury, do not exceed the rated load capacity of the machine. If the machine is not on level ground, load capacities will vary. Check for and follow all applicable laws and regulations when lifting objects. 20. Power Socket for 12 Volt (Optional) This is a power socket for only 12V DC devices. This socket can be used for charging a cellular phone or powering a small 12V DC electrical device.

12 V Open the cap when using it. NOTE: Avoid damage to electrical system. This socket is designed for small electrical capacity devices only. Do not use this socket for large electrical capacity devices. 7 A FG017015 Figure 30 DX225LC-3 Operating Controls 2-16