Password Activated If a password has already been set and the system has been "LOCKED", the password display will appear on the screen once the functional check has been completed. Enter the password into the text area and then engage the starter. NOTE: Refer to “Password Setting” on page 2-62, for further details. IMPORTANT If the password does not match the stored password, the engine will not start. 1. Fuel Gauge Shows remaining fuel quantity in tank. WHITE ZONE ( ) - Indicates a normal fuel quantity. RED ZONE ( ) - Indicates that fuel level is low. E F If the gauge pointer moves into the red zone, the fuel level symbol will turn "ON", and be displayed in the screen.
Stop operation and immediately and add fuel. NOTE: See “7. Display Warning Symbols” on page 2-29, for location of this warning symbol and others. FG018115 Figure 53 Check the fuel level on firm and level ground. NOTE: Only use Ultra Low Sulfur Diesel fuel and API- CJ-4/ACEA-E9 grade engine oil. 2. Engine Coolant Temperature Gauge The colored bands indicate the temperature of the engine coolant. H WHITE ZONE ( ) - Indicates temperature is within the normal operating range. RED ZONE ( ) - Indicates temperature is too high. During operation, the pointer must be in the white zone.
C If the gauge pointer moves into the red zone, the engine coolant temperature warning light will turn "ON", a warning buzzer will sound, and the engine speed will be automatically reduced. Allow the engine to run at "LOW IDLE" until temperature gauge registers in the white zone again. When the white zone is reached, allow the engine to idle for an additional three - five minutes before stopping the engine. If not allowed to idle, heat surge may develop Figure 54 FG018116 Operating Controls 2-25 DX225LC-3