which will damage the engine. Allowing the engine to idle will dissipate heat. Check the coolant level, look for a loose fan belt, inspect for debris around radiator, etc. When the temperature reaches the normal range, the engine speed will automatically recover. 3. Hydraulic Oil Temperature Gauge The colored bands indicate the temperature of the hydraulic oil. H WHITE ZONE ( ) - Indicates temperature is within the normal operating range. RED ZONE ( ) - Indicates temperature is too high. During operation, the pointer must be in the white zone. C If the gauge pointer moves into the red zone, the hydraulic oil temperature symbol will turn "ON", and be display in the screen.
Allow the engine to run at "LOW IDLE" until temperature gauge registers in the white zone again. FG018117 Figure 55 NOTE: See “7. Display Warning Symbols” on page 2-29, for location of this warning symbol and others. 4. Multifunction Gauge and Graphic Information Area AM When the engine starter switch is turned to "I" (ON) position, a LOGO will appear on the display screen for about two seconds. H H E F When the LOGO disappears, the multifunction gauge and graphic information screen will appear. rpm C C Min Max The engine rpm is normally displayed at the bottom of the screen when the starter switch is first turned "ON". A digital clock is located at the top of the display.
FG018118 Figure 56 By using a combination of the mode selector buttons, information for filters and oils can also be displayed. The display can also be set for the desired language. Refer to the “User Menu” on page 2-43 for the language selection and information display sequences. DX225LC-3 Operating Controls 2-26