Attachment Use Breaker 1 Setting The attachment use is designed to determine whether relevant attachments are used or not. If set up as enable, the relevant attachment can be used. If set up as disable, the relevant attachment cannot be used. Locate the cursor at the attachment use. Then, click on the jog switch to set up enable/disable. NOTE: If you select an attachment set up as disable, the pop-up window "Currently Used Item!" is displayed for three (3) seconds disabling the setup. FG018497 Figure 119 NOTE: If an attachment is enabled it can be a selectable attachment in the attachment select. Toggle This item sets the applicability of the toggle of breaker button.
If toggle is selected, the breaker will continue operation when the breaker button is pressed once, and reset when pressed again. If the toggle is released, the breaker is actuated while the breaker button is being pressed. Max E/G Limit The max E/G Limit is set up to define the flow rate limit discharged when using attachments. Operate the jog switch to move the cursor to the max E/G limit. Then, click on the jog switch to convert into the editing mode. At the editing mode, operate the jog switch clockwise/ counterclockwise to determine the desired max. engine limit. Then, click the jog switch to complete setup.
At the editing mode, press the ESC button to disable the editing mode and the saving of the setup value. The change value by stage in the jog switch operation is 100 rpm. Max Pressure (ATT) The max pressure (ATT) can be set up as the max pressure of the attachment by the user according to the attachment’s specifications. Max Flow (Pump) The max flow (pump) is the pump's max. flow rate discharged when using attachments. It needs not to be set up by the user, and it is automatically determined according to the max. engine limit setup value.
DX225LC-3 Operating Controls 2-50 Attachment Use Button Type Max E Max E/G Limit /G Limit Max F low(Pump) Max Flow(Pump) 2 Pum p OptiConurrently Us2e Pdu mItpe mOp!tion er Setting Max Flow