Doosan DX225LC-3 — 11. Heating Operator's Seat

9. Left and Right Control Stand Height Adjustment The left and right dials (2, Figure 231) at the lower part of the seat can be turned to adjust the elevation height of each control stand. (± 1.2 in (± 30 mm)) It can be used to adjust the height of the control joystick. 10. Adjusting Height/Angle of Armrest It is possible to adjust height of armrest by removing three bolts (2, Figure 232) holding armrest to driver's seat, and moving armrest up or down by intervals of 0.8 in (20 mm), and then installing armrest. Lift armrest slightly (1, Figure 232) and rotate dial on bottom of support to left and right to adjust angle of armrest. 1 2 Figure 232 FG019076 11.

Heating Operator's Seat The air suspension seat can be heated. The heater switch is found on left-hand side of seat back. To heat the seat, press and hold switch until desired heat level is obtained. When heating is not needed or seat is warmed, turn switch to "OFF" position. The seat warmer has a primary thermostat that allows it to operate between 28° - 37°C (82° - 99°F). At 37°C (99°F) the primary thermostat stops heating the seat. NOTE: If the primary thermostat fails, there is a secondary (safety) thermostat that operates between 32° - 41°C (90° - 106°F). At 41°C (106°F) the secondary (safety) thermostat stops heating the seat.

If the seat is heating up to a higher than normal temperature, have seat serviced immediately. Figure 233 FG015816 DX225LC-3 Operating Controls 2-86