Lubrication and Filters 1. Change engine oil and replace oil filter after first 50 hours of operation. 2. Change swing reduction device oil after first 250 hours of operation. 3. Change hydraulic oil return filter after first 250 hours of operation. 4. Replace travel and reduction gear oil after first 250 hours of operation. NOTE: For the replenishment of oil or grease, refer to “Inspection, Maintenance and Adjustment” on page 4-1 of this manual. STARTING AND STOPPING ENGINE Inspection Before Starting Engine Walk Around Checks WARNING AVOID DEATH OR SERIOUS INJURY If flammable materials such as leaves, paper, etc.
are allowed to accumulate on high temperature components, such as the engine muffler and turbo, a fire can occur. Fuel, lubricant, and hydraulic oil leaks can cause a fire. Clean machine, remove all flammable materials from machine, and repair machine before operating. Before starting engine, inspect the following items. If any problem is found, repair it before machine operation. 1. Overall Check for damage, wear, crack, oil leakage, play in work equipment, cylinders, linkages and hoses. Check the undercarriage for damage, wear, crack, oil leakage and loose bolts. Check for problems in doors, handrails, guardrails, steps and loose bolts.
Clean and check cabin glass, rearview mirrors, rear view camera and lights. Clean and check monitor, switches and gauges in the cabin. DX225LC-3 Operation 3-2