Doosan DX225LC-3 — Checks Before Starting Engine

2. Cleaning Remove dirt and debris from around engine, radiator, oil cooler and battery. Check and remove flammable material around muffler, turbocharger, battery or other high temperature components. Clean and inspect fins of radiator, oil cooler, CAC (Charged Air Cooler), fuel cooler and condenser. 3. Engine system Check for coolant and oil leakage around the engine and cooling system. 4. Fuel system Drain water and sediment from fuel tank and water separator. Check for fuel leakage in fuel system. 5. Hydraulic system Check for hydraulic oil leaks, damaged tubing and hoses and interference points of components. 6.

Electric system Check for damaged electrical cables and loose or missing connectors. 7. Lubrication Perform all daily and periodic maintenance services. Perform services according to reading shown on hour meter. 8. Safety Perform a machine walk-around. Make sure that no one is under the machine or performing any maintenance on it before starting engine. 9. After starting machine Check that all operational controls and components are in proper operating condition and are functioning correctly. Stop operation and correct any problems before continuing work. Checks Before Starting Engine Before starting engine, inspect the following items.

If any problem is found, repair it before machine operation. If the oil, fuel or coolant level are below the "LOW" mark, add it. For detail method, see “10 Hour / Daily Service” on page 4-24. 1. Grease boom, arm and front attachment pins. 2. Check engine oil level. 3. Check level of hydraulic oil tank. 4. Check fuel level. Operation 3-3 DX225LC-3