5. Check oil level of swing reduction device. 6. Clean dust net in front of oil cooler and intercooler. 7. Check cooling system and refill as required. 8. Check level of window washer liquid. 9. Inspect the bucket teeth and side cutters for signs of wear. 10. Inspect engine fan blade. 11. Check air intake system. 12. Inspect seat belt for any damage and proper operation. 13. Inspect the structure for cracks and faulty welds. 14. Check the operation of all switches. 15. Check the operation of all exterior lights, horn, travel alarm/ swing alarm (if equipped), rear view camera and control console indicator and monitor lights.
Operational Checks Before Starting Engine WARNING AVOID DEATH OR SERIOUS INJURY Unlock When leaving operator's seat, move the safety lever to "LOCK" (Figure 1) position and stop engine to prevent accidental activation of the work levers and controls. 1. Move safety lever to "LOCK" position (Figure 1). EX1300566 Figure 1 Lock 2. Fasten seat belt. Check for proper operation and condition. 3. Set all operation levers in "NEUTRAL". NOTE: Be careful not to move any switches when starting engine. 4. Rotate the starter switch to "I" (ON) position (Figure 2). Check all indicator lights. A warning buzzer will sound for about two seconds.
After two seconds, all lights except the following will turn "OFF". O I Charging warning light Engine oil pressure warning light Engine coolant temperature gauge Fuel gauge Hydraulic oil temperature gauge Figure 2 FG018147 NOTE: If all the indicator lights do not come "ON" when the key is first turned, there is a problem. Engine rpm (0 rpm) digital readout DX225LC-3 Operation 3-4