Engine Start WARNING AVOID DEATH OR SERIOUS INJURY Start the engine after sounding horn and making sure there are no people or obstacles in the area. 1. Perform all steps in “Operational Checks Before Starting Engine” on page 3-4. 2. Set engine speed control dial to "LOW IDLE" (Figure 3). If control dial is at "HIGH IDLE", the engine will accelerate suddenly and cause damage to the engine. 3. Sound horn. FG018148 Figure 3 4. Turn starter switch to "I" (ON) position. 5. Enter password. NOTE: If the security system is "LOCKED", a four-digit password will be required to start the engine. If the system is "UNLOCKED", no password will be required and this display screen will not appear.
Figure 4 FG018474 " " 6. Turn starter switch to (START) position (Figure 5). Engine should start in approximately five (5) seconds. O I IMPORTANT If the engine does not start after approximately fifteen seconds of cranking, release the starter switch. Wait about five minutes and repeat above steps. 7. After engine has started, release key. Key will return to "I" (ON) position (Figure 5). FG018149 Figure 5 8. Follow procedures in “Hydraulic System Warm-up” on page 3-12. Operation 3-5 DX225LC-3 Enter Password Owner Password Enter Owner Password