TRAVEL WARNING AVOID DEATH OR SERIOUS INJURY 1. When moving travel controls forward, tracked excavator will move in the direction of the idlers. Wheeled excavator will move in the direction of steering axle. 2. Before moving, make sure there are no persons or property in the way or on the machine. No riders. Sound the horn to alert workers and bystanders that you are about to move the machine. 3. Always be sure the path is clear during travel. 4. Use extreme caution when reversing travel. Be sure there is a clear path behind the machine. 5. Operate the travel control levers smoothly to avoid sudden starts or stops. 6.
Before leaving the operator's seat, make sure to lock out all control systems and stop engine to avoid accidental activation of controls. Automatic Travel Speed Control WARNING AVOID DEATH OR SERIOUS INJURY Do not change the travel mode while traveling. Always use speed mode "O" when traveling down a slope. Do not change to speed modes indicated "I" or "II" while going down a slope. Only change travel mode after coming to a complete stop. Two travel speed ranges can be selected by using the travel speed selector switch on the control panel (Figure 29). O I II "O" (LOW) - In this position low travel speed and a higher torque are selected.
"I" (HIGH) - In this position high travel speed and a lower torque are selected. "II" (AUTOMATIC) - Setting the control at the "II" position enables the machine to change to a different speed range automatically. This change happens automatically depending on the hydraulic oil pressure in the travel circuit. When hydraulic oil pressure rises, the travel speed is automatically set to low. An example is if the machine is traveling on a flat, solid surface, the higher speed range would be used. When a slope is encountered, the speed drops and the travel circuit hydraulic pressure rises, causing the control circuit to shift to the higher torque, lower speed range.
Figure 29 FG016016 Operation 3-17 DX225LC-3