Doosan DX225LC-3 — Safety Lever

Checks and Maintenance After Stopping Engine 1. Park the machine on dry and hard ground. 2. Repair excavator if there are any coolant or oil leaks. 3. Inspect front attachment and undercarriage for abnormal appearances. Check that attachment is secure. Correct any problems. 4. Fill fuel tank and drain any water collected in the fuel system to prevent it from freezing. 5. Inspect and remove accumulated flammable materials, such as leaves, paper etc., in engine compartment. 6. Clean all mud, debris, etc. from undercarriage and tracks. Make sure that all steps and handholds are clean, and that operator's cabin is clean.

SAFETY LEVER WARNING AVOID DEATH OR SERIOUS INJURY When leaving operator's seat move the safety lever to "LOCK" position and stop engine to prevent accidental activation of the work levers and controls. Be careful not to move the work levers (joysticks) when moving safety lever. 1. Move safety lever (Figure 28) down into "LOCK" position. When safety lever is in the "LOCK" position, the front attachment, work controls, swing and travel movement will be disabled. NOTE: Lower bucket (front attachment) to ground. Place all control levers in "NEUTRAL" and stop engine, before moving the safety lever. Unlock 2.

Move safety lever (Figure 28) on "UNLOCK" position, by pulling it up before starting work. NOTE: When the engine is not running, but the safety lever is in the "UNLOCK" and the starter key is turned "ON", moving the work levers (joysticks) can result in movement of the work equipment. The charged accumulators in the system will provide pilot pressure for control valve spool movement. Figure 28 Lock EX1300566 DX225LC-3 Operation 3-16