Operation 3-27 DX225LC-3 Diesel Particulate Filter - Service Chart Level/Light Status Filter Status Requested Action Soot in DPF is 80% or less Active Regeneration "ON" (RED) Soot in DPF is 100% or less Manual (Forced) Regeneration (Service Regeneration) "FLASHING" (RED) Soot in DPF is 120% or less Manual (Forced) Regeneration Immediately (Service Regeneration) "FLASHING" (RED) + Engine Output Power Reduction Soot in DPF is 120% or more Service the Emission Control System Immediately Passive Regeneration The engine provides adequate exhaust gas temperature for regeneration. Active Regeneration No action by the operator is required to start active regeneration.
Regeneration of the DPF is automatically activated by the engine control unit (ECU) when particulate matter or "soot" has reached certain levels in the DPF. When the soot quantity in the DPF is near 80%, active regeneration will start. If the soot quantity exceeds 80%, the operator should activate manual (forced regeneration). When the soot quantity exceeds 120%, the engine warning light turns on and the engine's output power is reduced to 50%. If this occurs, service the emission control system. Contact your DOOSAN distributor for more information. Active regeneration can occur anytime the engine is running, while operating the machine or when the machine is parked.
During regeneration, the regeneration light and the high temperature warning light turn "ON" to alert the operator of hot engine exhaust gases. Machine operation can continue, but the operator should keep engine exhaust away from flammable materials. The operator can choose to "inhibit" active regeneration, if operating conditions are not favorable to hot engine exhaust temperatures (e.g. working near flammable materials). The regeneration process can last for 30 minutes or longer. When completed, the regeneration lights on the monitor will turn "OFF". IMPORTANT Do not stop engine during regeneration. This can severely damage the DPF.