Manual (Forced) Regeneration The regeneration process of the DPF is manually (forced) activated by the operator when the operator chooses to start the regeneration process. Manual (forced) regeneration may be required if the operator "inhibits" the active regeneration process for an extended period of time because the operating conditions are not favorable to hot engine exhaust temperatures (e.g. working near flammable materials). WARNING AVOID DEATH OR SERIOUS INJURY OR PROPERTY DAMAGE Exhaust gas temperature and exhaust system components are very hot during manual (forced) regeneration. FOLLOW THESE INSTRUCTIONS DURING MANUAL (FORCED) REGENERATION:
Keep flammable material and explosive gases away from exhaust system during manual (forced) regeneration. FG023282 Figure 52 Park machine in open area that is well ventilated. Lower boom and position arm in vertical position as shown in Figure 52. Move safety lever to "LOCK" position. Engage parking brake (Wheel excavators only). Operator must be in operator's position during the regeneration process. Keep bystanders away. NOTE: Slight movement of the bucket (work tool) hydraulic cylinder can occur during the manual (forced) regeneration process. Procedures for manual (forced) regeneration by the operator. 1. Park machine in a well ventilated area and away from flammable materials.
Position machine and lower boom as shown in Figure 52. 2. Set up machine in the following manner: A. Operate machine until engine coolant and oil temperatures are above 40°C (104°F). B. Move engine speed to "LOW IDLE". C. Put transmission lever in "NEUTRAL" and engage parking brake (Wheel excavator only). 3. Move safety lever to "LOCK" position. DX225LC-3 Operation 3-28