Doosan DX225LC-3 — Right-hand Work Lever (Joystick) (Figure 62 and Figure 65)

Work Levers (Joysticks) (ISO Pattern) 1 5 WARNING 4 3 8 7 2 6 AVOID DEATH OR SERIOUS INJURY Check surrounding area before swinging. When operating a lever while in auto idle, proceed with caution because the engine speed will increase rapidly. Keep bystanders away. NOTE: When starting work, move work levers (joysticks) slowly and check movement of swing and front attachment. FG018404 This equipment is manufactured using the lever control pattern described in ISO standards. Do not change valving, hoses, etc., that would change this control pattern. The boom, arm and bucket movements and swing direction of work levers (joysticks) are as follows:

Figure 62 Left-hand Work Lever (Joystick) (Figure 62 and Figure 63) 1. Arm dump 2. Arm crowd 3. Left swing 4. Right swing NOTE: The swing brake is spring applied and hydraulically released. It is always engaged when the work lever (joystick) is in "NEUTRAL" or the engine is stopped. Figure 63 NOTE: When operating the arm, it may stop momentarily. When the arm is operated, the weight of the arm can cause it to move faster than the amount of oil being supplied. FG000120 Figure 64 Right-hand Work Lever (Joystick) (Figure 62 and Figure 65) 5. Boom down 6. Boom up 6 7. Bucket crowd 8. Bucket dump 5 7 NOTE:

Even after stopping the engine, the front can be lowered to the ground by the operating work lever (joystick) by moving safety lever to "UNLOCK" position and turning starter switch "ON". 8 Figure 65 FG018406 Operation 3-35 DX225LC-3 4 1 3 2 FG01840