Doosan DX225LC-3 — Reversal (If Applicable)

Reversal (If Applicable) 1. Place the bucket on a flat surface. 5 A IMPORTANT 6 When removing the pins, place the bucket so it is in resting slightly on the ground. If down pressure is applied to the bucket, the resistance will be increased and it will be difficult to remove pins. After removing the pins, make sure they are clean and do not allow mud, sand, or other debris to get on them. Dust seals are fitted at both ends of the bushings. Be careful not to damage them. B FG020108 Figure 113 2. Remove double nut on the stopper bolt for arm pin (A, Figure 113) and link pin (B, Figure 113), remove bolt, pull out arm pin (A, Figure 113) and link pin (B, Figure 113), and then remove bucket.

2 1 FG018433 Figure 114 3. After removing the bucket, reverse it. 4. Align arm (5, Figure 113) with replacement bucket hole (1, Figure 114), then align link (6, Figure 113) with hole (2, Figure 114), then insert greased coated pins (A, Figure 113) and (B, Figure 113) into hole (1, Figure 114) and hole (2, Figure 114) respectively. 2 IMPORTANT 1 When reversing, do not install an O-ring. Keep the O-ring in a safe place until using it next. Figure 115 FG018434 5. Install the stopper bolts and nuts for each pin. 6. Lubricate with grease thoroughly until grease comes out from the end face. IMPORTANT When replacing the bucket, replace the dust seal if it has been damaged.

If a damaged seal is used without being replaced, sand and dirt may enter the pin portion and cause abnormal wear of the pin. DX225LC-3 Operation 3-54