Doosan DX225LC-3 — Replacement

Replacement 1. Place the bucket in contact with a flat surface. 5 A IMPORTANT 6 When removing the pins, place the bucket so it is resting slightly on the ground. If down pressure is applied to the bucket, the resistance will be increased and it will be difficult to remove pins. After removing the pins, make sure they are clean and do not allow mud, sand, or other debris to get on them. Dust seals are fitted at both ends of the bushings. Be careful not to damage them. B FG020108 Figure 110 2. Remove double nut from bolt for arm pin (A, Figure 110) and link pin (B, Figure 110), remove bolt, pull out arm pin (A) and link pin (B, Figure 110), and then remove bucket. 1 2 3.

Align the arm (5, Figure 110) with holes (1, Figure 111) of the replacement bucket and the link (6, Figure 110) with holes (2, Figure 111), then insert grease coated pins (A, Figure 110) and (B, Figure 110) into hole (1, Figure 111) and hole (2, Figure 111) respectively. FG018432 Figure 111 4. When installing the bucket, for arm pin portion (A, Figure 110), fit O-rings (3, Figure 112) on bucket (4, Figure 112) in the position shown in the diagram on the right. After inserting the pin, position them in the standard groove. 5. Install the stopper bolts and nuts for each pins. 6. Lubricate with grease thoroughly until grease comes out from the end face.

Figure 112 IMPORTANT FG019639 4 3 5 3 When replacing the bucket, replace the dust seal if it has been damaged. If a damaged seal is used without being replaced, sand and dirt may enter the pin portion and cause abnormal wear of the pin. Operation 3-53 DX225LC-3