Doosan DX225LC-3 — To Activate Shear

To Activate Shear 1. Set work mode to "SHEAR" position using button (1, Figure 127) 1 FG018376 Figure 127 2. Move the thumb switch on the top of the right-hand work lever (joystick) to shear. Moving thumb wheel upward will "OPEN" the work tool. PM H H 3. Move the thumb switch on the top of the right-hand work lever (joystick) to shear. Moving thumb wheel downward will "CLOSE" the work tool. E Work Mode F rpm C C Min Max USB E DIG ISO EX1300479 Figure 128 Figure 129 IMPORTANT Cutting train or crane rails, engine crankshafts, welded fabrications, bearing, shafts, and other hard metals will increase the wear rate on the cutting edges and the shear. Operation 3-61 DX225LC-3 FG027217