Lifting Unknown Weight When the weight of the load is unknown, the person responsible for the job shall determine that weight of the load does not exceed the machine LOAD RATING CHART at the radius at which it is to be lifted. WARNING SIDE LIFT ZONE SIDE LIFT ZONE AVOID DEATH OR SERIOUS INJURY If a load is picked-up from the front zone and swung into the side zone, a tip over could result. Do not exceed the rated load capacity for the lift zone that will be used. REAR LIFT ZONE Lifting Known Weight HAAD3842 Figure 140 The load rating chart is the determining factor when lifting known weights. Whenever possible, lift and swing loads between the front idler area.
Pick and Carry The machine can pick and carry loads. It is recommended that when traveling with a suspended load, you evaluate the prevailing conditions and determine the work site precautions required in each case. The following factors must be considered before attempting to pick and carry a load. Align the boom with the forward direction of machine travel. Maintain this boom position when turning the machine. Turn only when necessary, at the slowest speed, and at a wide turning radius. 1. Use the shortest lifting radius distance possible. 2. Keep the load as close to the ground as conditions will permit. 3. Provide tag lines to prevent load from swinging back and forth.
This can cause a change in the lift radius could exceed the load chart rating or cause a tip over. 4. Travel speed will depend on work site conditions. 5. Avoid sudden starts and stops. DX225LC-3 Operation 3-68 NT ON