Doosan DX225LC-3 — Lifting Objects

LIFTING OBJECTS IMPORTANT There may be local or government laws or regulations governing the use of excavators for the lifting of heavy loads. Always contact local and government agencies and follow all applicable laws and regulations. When this machine is used in object handling applications, the machine must be properly configured and operated properly. Ensure the following safety working devices equipped and operated. Lifting eye for load hooking Hose burst protection on both boom and arm Overload warning devices To prevent injury, do not exceed the rated load capacity of the machine. If the machine is not on level ground, load capacities will vary.

Short slings will prevent excessive load swing. Use the lifting eye on the bucket that is provided to lift objects. Always try to maintain the lifting eye (Figure 139) straight below the centerline of the arm and bucket pin. In this manner the weight of the load is being primarily held only by the pin, and not by the bucket cylinder, link, and link pins. When a lifting eye is used, the sling/lifting device must be fastened to the eye in a manner that will not allow it to come loose. The most stable position is over the corner of the machine. For best stability, carry a load as close to the ground and machine as possible.

Lift capacity decreases as the distance from the machine swing centerline is increased. HAAD3830 Figure 139 Operation 3-67 DX225LC-3