5. Always keep the fuel tank fully filled after completion of the operation. Always drain water from the fuel tank before and after the operation. In addition, check the water separator, and drain it if required. The fuel filter, if frozen, may interrupt the flow of fuel. Periodically remove water from the fuel tank, drain water from the filter, and replace the filter upon regular basis. To prevent fuel from being clogged due to formation of wax in fuel, make sure that wax formation point of fuel is lower than atmospheric temperature. WARNING AVOID DEATH OR SERIOUS INJURY Explosion of the fuel tank may cause serious injury or death.
Never attempt to directly heat the fuel tank with open fire . 6. Lubricate entire machine according to “Lubrication and Service Chart” on page 4-16, in this manual or lubrication chart on machine. 7. Start engine and allow it to reach normal operating temperature before operating. If mud and ice collects and freezes on any of moving parts while machine is idle, apply heat to thaw frozen material before attempting to operate machine. Operate hydraulic units with care until they have reached a temperature which enable them to operate normally. Check all machine controls and functions to be sure they are operating correctly. 8.
An extra outer air filter must be kept in operator's cabin to replace element that could become iced and cause restricted airflow to engine. 9. Clean off all mud, snow and ice to prevent freezing. Cover machine with a tarp if possible, keep ends of tarp from freezing to ground. Operation in Extreme Heat Continuous operation of machine in high temperatures can cause machine to overheat. Monitor engine and hydraulic system temperatures and stop machine to let it cool, when necessary. 1. Make frequent inspections and services of fan and radiator. Check coolant level in radiator. Check grilles and radiator fins for accumulation of dirt, debris and insects which could block cooling passages.
DX225LC-3 Operation 3-70