Welding Instructions Cut off power. Wait for approximately one minute after turning off engine starter switch key, and then turn battery disconnect switch to "OFF" position. Do not apply more than 200 V continuously. Connect grounding cable within 1 m (3.3 ft) of area to be welded. If grounding cable is connected near instruments, connectors, etc., instruments can be damaged. If a seal or bearing happens to come between part being welded and grounding point, change grounding point to avoid these types of parts. Do not use area around work equipment pins or hydraulic cylinders as grounding point.
Do Not Drop Things Inside Machine When opening inspection windows or oil filler port of tank to perform inspection, be careful not to drop nuts, bolts, or tools inside the machine. If parts are dropped inside machine, it can cause damage and/or improper operation of the machine. If you drop anything inside the machine, always remove it immediately. Dusty Work Site When working at a dusty work site, do the following: Clean radiator fins and other parts of heat exchange equipment more frequently, and take care not to let fins become clogged. Replace fuel filter more frequently. Clean electrical components, especially starting motor and alternator, to avoid accumulation of dust.
When checking and replacing oil or filters, move the machine to a place where there is no dust and take care to prevent dust from entering system. Avoid Mixing Lubricants If a different brand or grade of oil has to be added, drain all old oil before adding new brand or grade of oil. Never mix different brands or grades of oil. Locking Inspection Covers Lock inspection cover securely into position with lock bar. If inspection or maintenance is performed with inspection cover not locked in position, it could fall and cause injury. DX225LC-3 Inspection, Maintenance and Adjustment 4-2