Hydraulic System - Air Bleeding When hydraulic equipment has been repaired or replaced, or hydraulic piping has been removed and installed again, air must be bled from circuit. For details, see “Venting and Priming Hydraulic System” on page 4-102. Hydraulic Hose Installation When removing part at locations with O-rings or gasket seals, clean mounting surface and replace with new parts. When doing this, be careful not to forget to assemble O-rings and gaskets. When installing hoses, do not twist them or bend them sharply. This will extend service life and prevent damaging hoses.
Checks After Inspection and Maintenance Works Perform checks after inspection and maintenance to prevent operation problems. Always do the following: Checks after operation (with engine stopped). Have any inspection and maintenance points been forgotten? Have all inspection and maintenance items been performed correctly? Have any tools or parts been dropped inside the machine? If parts are dropped inside the machine and get caught in lever linkage mechanism, and this could cause improper operation of the machine. Are there any coolant or oil leaks? Have all nuts and bolts been tightened? Checks when operating engine.
For details of checks when operating engine, see “Safety Precautions” on page 4-4 and pay careful attention to safety. Are inspection and maintenance items working properly? Is there any leakage of fuel or oil when engine speed is raised? Inspection, Maintenance and Adjustment 4-3 DX225LC-3