Doosan DX225LC-3 — Fuel

HANDLING OIL, FUEL, COOLANT Oil Oil is used in the engine and hydraulic equipment under extremely severe conditions (high temperature, high-pressure, etc.) and deteriorates with use. Always use oil that matches the grade and maximum and minimum ambient temperatures recommended in this manual. Even if oil is not dirty, always change oil at specified interval. Always be careful when handling oil to prevent any impurities (water, metal particles, dirt, etc.) from getting in. Operating problems with the machine can be caused by impurities in oils. Take particular care not to let any impurities get in when storing or adding oil. Never mix oils of different grades or brands.

Always add specified amount of oil. Having too much or too little oil can cause operational problems. If oil in work equipment is not clear, there may be water or air getting into circuit. In such cases, contact your DOOSAN distributor. When changing oil, always replace related filters at same time. Fuel NOTE: Only use Ultra Low Sulfur Diesel (ULSD) fuel and API-CJ-4/ACEA-E9 grade engine oil. To ensure good fuel consumption characteristics and exhaust gas characteristics, the engine mounted on this machine uses an electronically controlled high-pressure fuel injection device. This device uses high precision parts and lubrication.

If low viscosity fuel with reduced lubricating ability is used, the durability of the fuel injection device could be affected. To prevent moisture in air from condensing and forming water inside fuel tank, always fill fuel tank after completing day's work. The fuel pump is a precision instrument and if fuel containing water or dirt is used, it cannot work properly. Be careful not to let impurities get in when storing or adding fuel. Always use fuel specified for temperature given in this manual. DX225LC-3 Inspection, Maintenance and Adjustment 4-8